Before using your machine, it's important to ensure everything is properly set up. This step guides you through basic checks like power connections, fastenings, and the laser head position to help prevent common issues and ensure smooth operation.
1.1 Install the Laser Head
Before use, please ensure the laser head is properly installed. You can refer to our short video to check if the installation is correct.
1.2 Check the Power Connection
Make sure the power is connected properly, and the power cord is secure to avoid any loose connections.
1.3 Check the Air Tube and Limit Switch Connections
Please confirm that the air tube and limit switch are correctly connected to prevent operational errors or malfunctions during engraving.
1.4 Ensure the Emergency Stop Switch is Released
Before use, make sure the emergency stop switch on the right side has been rotated and released, allowing the machine to start normally.Before use, make sure the emergency stop switch on the right side has been rotated
1.5 Power Indicator Light is On
Check if the machine’s power indicator light is on, which indicates that the machine is powered properly.
When the power button indicator light keeps flashing:
Step 1: Press and hold the power button on the machine to turn it off, then unplug the USB cable and the power cord.
Step 2: Reinsert the USB cable and power cord into the machine.
Step 3: Briefly press the power button on the machine to turn it on. The machine should start up normally.
If the indicator light still keeps flashing after completing the above steps, please install the software patch:
